News Details

You are here: Home » News » Carbide Burrs » Four Steps of Hard Alloy Cemented Carbide Cutting Burr Mold Manufacturing

Four Steps of Hard Alloy Cemented Carbide Cutting Burr Mold Manufacturing

Views:0     Author:Site Editor     Publish Time: 2020-08-29      Origin:Site


The key points that should be paid attention to in processing of Hard Alloy Cemented Carbide Cutting Burr wire drawing die blanks and die sleeves and core assembly process; manufacturing is mainly divided into four steps: 

1. mold blank processing; 

2. assembly interference; 

3 .Drawing die set processing; 

4. Assembly process


carbide burrs


1 Mold blank processing


Cemented carbide wire drawing die cores will shrink during sintering process. Different batch numbers have different shrinkage due to differences in composition, pressing and sintering processes; different parts of die blank often form a "saddle" due to different shrinkage. Or "bell mouth" shape. Although fluctuation of die blank's dimensions meets standard of die blank, it far exceeds interference requirement of die set, which causes serious unevenness in prestress of die core during assembly and greatly reduces service life of die. Therefore, die blank must for external cylindrical grinding, a special fixture is required on grinder and a diamond wheel is used for grinding.


carbide burrs


2 Interference of installation


In order to obtain a certain prestress of mold core during installation, inner hole diameter of mold sleeve must be smaller than outer diameter of mold core, and difference between two is called interference. The amount of interference should be determined according to die core size and deviation, drawing stress and inserting method. Table 1 shows actual interference when mold is installed. The die set is inlaid with two kinds of hot pressing method and cold pressing method. The cold pressing method has a small interference and a small pre-pressing stress. It is mostly used to manufacture small-sized wire drawing dies for drawing soft metals.


carbide burrs


3 Mold sleeve processing


The die sleeve is formed by turning on a lathe, and control points during processing are as follows:

(I) Inner diameter roughness of die sleeve must reach 0.80-I. 6 m, which is conducive to close cooperation with mold sleeve;

(2) Inner diameter of mold sleeve must correspond to outer diameter of mold blank to ensure accuracy of interference of each mold;

(3) Bottom surface of inner hole of mold sleeve and outer end of mold must be parallel, and ensure that it is perpendicular to center line of mold hole after sleeve is installed;

(4) Ovality of inner hole of die sleeve should be as small as possible, and should not be greater than 0.02 mm. The outer surface of mold sleeve should be polished during hot assembly to ensure uniform cooling after assembly.


carbide burr


4 Installation process


The cold-pressing assembling process is to press mold blank into mold sleeve with a press at room temperature. The cold pressing method requires accurate interference and high dimensional accuracy of mold core and mold sleeve. The advantage is that it does not require heating equipment, saves energy and reduces consumption costs.

 


Kone Carbide Tool Co., Ltd.
 
E-mail:   Click to show the Email
 
Tel:  +86-28-61716272
 
Mobile: +86 13648013796

Add:  No. 777 Haike Road Cross-Strait Industrial Park Wenjiang, Chengdu,610000,P.R.China
We use cookies to enable all functionalities for the best performance during your visit and to improve our services by giving us some insight into how the website is being used. Continued use of our website without having changed your browser settings confirms your acceptance of these cookies. For details please see our cookies
×